请选择 进入手机版 | 继续访问电脑版

超级大本营军事论坛

 找回密码
 加入超大军事

QQ登录

只需一步,快速开始

查看: 2880|回复: 8
收起左侧

毛子的芯二级氢氧机rd-0150属于什么水平?

[复制链接]
发表于 2019-6-8 19:50 | 显示全部楼层 |阅读模式

更多精彩专业军事内容,期待你的加入!

您需要 登录 才可以下载或查看,没有帐号?加入超大军事

x
本帖最后由 Asuka·Shin 于 2019-6-8 19:58 编辑

012403yjqvme1j3zzeaazf.jpg
energia5v_vr_info_1.jpg
urm2v_infograph_1.jpg

毛子计划用于安加拉-5V及新百吨级火箭“能源-5”的芯二级(毛子称为三级)的氢氧机。
在2014年旧的方案中是计划使用4台并联,总推力160吨。在2017年提出的新方案中数量减半为2台并联。
但查到的资料称,rd-0150的设计推力指标由之前的40吨提升为77吨甚至80吨,所以总推力基本不变。
而比冲则是462秒,应该属于比较高的水平了吧?估计是分级循环,综合技术指标大概高于日本的LE-7?

Hydrogen-based URM-2V

The architecture and capabilities of the newly developed third stage for the Angara-5V was expected to be similar to previously proposed hydrogen boosters, such as such the second stage of the cancelled Rus-M launch vehicle or the UKVB stage that was previously proposed as the third stage for the Proton-M2 and for the Angara-5 rockets. According to an unofficial estimate made by a veteran of the rocket industry Dmitry Vorontsov, the new booster was to have a total propellant mass of around 48 tons and sport a propulsion system producing 40 tons of thrust with a specific impulse of 462 seconds.

Under pressure to give the Angara-5V its hard-to-achieve payload of 37 tons, designers aimed to keep the dry mass (structure without propellant) of the URM-2V stage to an absolute minimum of six tons. However, by the end of April 2015, some conservative estimates pointed toward a dry mass up to two times higher.

Choosing the propulsion system

Still, the biggest challenge to the initial design of the URM-2V stage was the selection of a propulsion system. In March 2015, Yuri Koptev said that the booster would be propelled by the yet-to-be-built RD-0150 engine.

The development of a new-generation propulsion system was apparently deemed more practical than any attempts to revive the Soviet-era hydrogen engines such as 11D57M (RD-57M) and KVD1 or later experimental RD-0122, KVD-1M3 and RD-0146 engines, even though the latter propulsion system was to be used on the second stage of the Rus-M rocket.

The developer of the RD-0150 engine -- KBKhA design bureau in Voronezh, promised to increase the projected thrust of a single RD-0150 engine from 40 to 77 tons, however, this capability would have to be confirmed in the course of the early work on the Angara-5V project. (744) According to Vorontsov, such a propulsion system could theoretically produce as much as 80 tons of thrust.

Other industry sources also said that although a one-engine propulsion system served as a baseline for the design of the stage, it presented its own technical challenges. The engine was expected to feature a special nozzle extension, which allowed to keep the length of the vehicle to a minimum. After the separation of the lower stage in flight, the extension would slide into operational position to provide a better performance for the engine. However, engineers would have to make sure that the rocket remains stable during the "cold" separation, when the lower URM-1 central booster had already dropped, but the upper URM-2V booster was yet to fire, leaving the entire vehicle in the unpowered free flight.

As an alternative to the one-engine design, the four-engine cluster also remained on the table in the first half of 2015. Engineers at KBKhA bureau were also re-examining the legacy from the RD-0122 engine for its possible use in the project. However by the end of April 2015, engineers reportedly favored a two-engine propulsion system, with each engine producing 45 tons of thrust.

In March 2016, First Deputy Director at GKNPTs Khrunichev Aleksandr Medvedev confirmed that it had been decided to equip the URM-2V with a pair of RD-0150 engines. In June 2017, Deputy Prime Minister Dmitry Rogozin promised to initiate the development of the RD-0150 engine, but he did not specify any timeframe for the project. At the time, the same engine was also expected to be used on the third stage of the future super-heavy launcher.
012403yjqvme1j3zzeaazf.jpg
energia5v_vr_info_1.jpg
urm2v_infograph_1.jpg
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-8 23:45 超大游击队员 | 显示全部楼层
YF77并联登月的翻版?
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-9 03:07 超大游击队员 | 显示全部楼层

Re.毛子的芯二级氢氧机rd-0150属于什么水平?

真空推80吨海平面推力大概60吨,这样可以芯装两台,然后两台rd170发动机作为助推器一级半入轨
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-9 06:56 超大游击队员 | 显示全部楼层

Re.毛子的芯二级氢氧机rd-0150属于什么水平?

吊打yf77
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-10 11:53 | 显示全部楼层

RE: 毛子的芯二级氢氧机rd-0150属于什么水平?


一个补燃一个燃气发生器循环的能比吗
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-10 13:14 | 显示全部楼层

RE: 毛子的芯二级氢氧机rd-0150属于什么水平?

启航太阳系 发表于 2019-6-8 23:45
YF77并联登月的翻版?

比YF77强多了
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-10 13:40 | 显示全部楼层
就目前看到的图分析吧,这个RD-0150肯定不是燃气发生器循环
但到底是分级还是膨胀不好说,图太少了
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-11 14:39 超大游击队员 | 显示全部楼层
研发到什么阶段了
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
发表于 2019-6-11 14:42 超大游击队员 | 显示全部楼层
squallgzy 发表于 2019-6-10 13:14
比YF77强多了

那相当于补燃的YF78?总之不需要YF220了
最具影响力军事论坛-超级大本营军事论坛欢迎你!超然物外,有容乃大。
您需要登录后才可以回帖 登录 | 加入超大军事

本版积分规则

关闭

超大推荐上一条 /1 下一条

监狱|手机|联系|超级大本营军事论坛 ( 京ICP备13042948号 | 京公网安备11010602010161 )

声明:论坛言论仅代表网友个人观点,不代表超级大本营军事网站立场

Powered by Discuz © 2002-2019 超级大本营军事网站 CJDBY.net (违法及不良信息举报电话:13410849082)

最具影响力中文军事论坛 - Most Influential Chinese Military Forum

GMT+8, 2019-6-17 07:10 , Processed in 0.035403 second(s), 9 queries , Gzip On, Redis On.

快速回复 返回顶部 返回列表